Автор Тема: Всеволновая антенна 2E0ILY  (Прочитано 5996 раз)

0 Пользователей и 1 Гость просматривают эту тему.

Оффлайн rw3adb

  • Ветеран
  • *****
  • Сообщений: 6338
    • Просмотр профиля
    • E-mail
Всеволновая антенна 2E0ILY
« : 14 Октябрь 2015, 04:05:04 »
Давненько еще, я спрашивал у Криса про его антенну. В прошлом году он вполне успешно принимал на неё и наших отсюда, и VO1NA, и прочих американцев и всю Европу.

Меня  основательно удивили возможности столь простой и низко подвешенной конструкции на таком количестве диапазонов.

Безусловно, свою лепту вносит факт того, что живёт он в сельской местности и нигде рядом не видно мощных источников помех или стоящих рядом домов соседей с китайскими зарядниками.

На днях, дело у него дошло до передачи....
Я поинтересовался у него, безусловно, на какую антенну он передавал - так оказалось, что на свою волшебную всеволновую рамку!
Итак - получается работает она от 136 КГц до 50 Мгц без каких-либо перестроек и дополнительных согласующих устройств!

UPD - ввёл вас всех тут в заблуждение.
на приём он действительно использовал её с ШПТ и на ДВ, в том числе.
А на передачу - закоротил питающую линию и использовал её как очень короткий вертикал 5-6м высотой с емкостной нагрузкой в виде этой самой рамки сверху.


От души поздравляю Криса с оглушительно успешным дебютом в качестве "передатчика" на ДВ!
А так же прилагаю его письма с пояснениями и картинку со схемой рамки.

Hi,  I  was using my big horizontal quad loop, about 25 to 30 feet off
the ground, two corners are higher than the other two. Corner fed with
ladder  line.  TX is a Kenwood TS-590, running its 5 Watt minimum, but
would  be  lower  outputs  as  i  reduce  the  audio drive in WSPR. My
Wattmeter is not accurate that low, but definitely LESS than 5W out.

The quad loop is about 380 feet in circumference. See attache.

Сегодняшнее письмо про детали по части передачи:

Thank you all for the congratulations and reports. Very early days
yet, and many improvements need making. The aerial is my HF horizontal
quad wire loop, up about 25 feet max, fed in a corner by my bungalow,
(its lowest point too, so not ideal...), using the shorted windowed
ladder line as the vertical. A six foot long ground spike near the
feed point is the only earth. I want to raise the loop higher, add a
ground wire under the perimeter, and add more ground spikes too. I may
try using a grounded electric fence as an addition too, it runs almost
underneath one leg of the loop.


As this is also my HF aerial I need to add some sort of relay to
disconnect the shorted feeder from the LF matching coil and connect to
a balun for feeding my HF stuff. Right now I can either use HF or LF
and changing means a trip outside and much fiddling about. I am
thinking of using an active whip and separate receiver for LF
reception and a grabber though.


I need to improve matching and resonance slightly, but intend changing
the feeder co-ax to the aerial for something less temporary. I built a
scopematch  and see the following right now, so room for improvement I
feel:

http://www.chriswilson.tv/scopemeter-tx-full-power.jpg

The driver is the DRV output at 1mW from my TS-590 feeding a W1VD pre
amp and W1VD frequency doubler, then running a G3YXM FET amp.

I noticed a hot smell from it last night, then it blew the RCD trip on
the house electric panel. It ran again, but again on higher power
ranges it did the same again. as it has over current and high SWR and
drive loss safety cut outs I suspected something in the power supply,
and indeed, it seems the toroidal mains transformer was getting hotter
than I would have liked. I am wondering it it has an internal
intermittent short? I may high pot test it later.



My  other  issue  is I have modded my TS-590 to use a VK3HZ GPS locked
master  oscillator, fed from my Trimble Thunderbolt GPS.


http://www.vk3hz.net/XRef/XRef_Home.html#XRef-Vx


It has worked perfectly for months. But now I am TX'ing on 136kHz it
is picking up RF, either into the Thunderbolt GPS itself, or a divider
board that offers divisions of 10MHz for other uses in the shack. I
see the square wave at 10MHz from the divider go crazy on my scope
when I TX, so I am not using the GPS locked oscillator and find my
signal is 3Hz off without it running. I am trimming on the actual rigs
frequency setting to compensate.


So  a  few  improvements to play with, and the issue of the GPS locked
oscillator  to  fix.  But  I am over the moon to be finally able to TX
rather than just listen.

A big step for me has been taken though! All the best.

--
Best regards,
 Chris                            mailto:chris@chriswilson.tv



« Последнее редактирование: 18 Октябрь 2015, 19:18:45 от rw3adb »
--_ _ _  _ _ _ --  --_   _   _-_  _--  _ _ _-- _- -_ _ -_ _ _

Оффлайн rw3adb

  • Ветеран
  • *****
  • Сообщений: 6338
    • Просмотр профиля
    • E-mail
Re: Всеволновая антенна 2E0ILY
« Ответ #1 : 02 Август 2021, 20:32:11 »
По случаю долетания R7NT летом до Криса 2E0ILY выяснились любопытные подробности приёма, которые стоит зафиксировать тут!

Chris, TNX for the reports!
You have a great RX setup!
July 31-Aug 1 Best QRB/reports R7NT acty
2021-08-01 00:00     R7NT     0.137539     -41     0     KN97lf     200     2E0ILY/1800     IO82qt     2991     298     30 (3)
2021-07-31 22:00     R7NT     0.137539     -44     0     KN97lf     200     PA0OCD     JO22li     2482     296     30 (1)
2021-08-01 00:34     R7NT     0.137540     -20     0     KN97lf     200     SM2DJK     KP03au     2180     335     2 (31)
2021-07-31 23:30     R7NT     0.137541     -23     0     KN97lf     200     SM3LNM     JP82qg     2150     329     2 (12)
2021-08-01 01:00     R7NT     0.137539     -36     0     KN97lf     200     DF6NM/1800     JN59nj     2060     287     30 (3)
2021-08-01 01:00     R7NT     0.137540     -42     0     KN97lf     200     SV8RV/1800     KM07ks     1811     241     30 (1)
2021-07-31 23:30     R7NT     0.137540     -26     0     KN97lf     200     UA3245SWL     KO85qw     974     354     2 (24)
2021-08-01 00:38     R7NT     0.137541     -22     0     KN97lf     200     UA3245SWL2     KO85ou     967     353     2 (6)
2021-07-31 21:30     R7NT     0.137541     -13     0     KN97lf     200     RZ3DVP     KO85nt     963     353     2 (48)
2021-07-31 21:50     R7NT     0.137540     -24     0     KN97lf     200     RN3AUS     KO85fn     943     350     2 (20)
FW30: TX-1 RX-4
FW2: TX-1 RX-0
WSPR2: TX-1 RX-5
(n) - it's the total number of the reports - it's the best result of the reports - it's the first result over time with the same levels
(n) - общее кол-во спотов от корреспондента - показан самый лучший - при одинаковых уровнях, выбран самый первый по времени
200W Output + W.sLoop
 
73! Alex R7NT  136.73.ru    AWLF 136.73.ru/h_aw
 
 
Свернуть
Воскресенье, 1 августа 2021, 11:56 +03:00 от Chris Wilson <dead.fets@gmail.com>:
 
Hello Rsgb-lf-group,

 
R7NT weak but coming through here in the Midlands.

2000 -43 1.1 1540 ` R7NT KN97 53
2030 -13 0.3 1434 ` DL7NN JO60 30
2100 -17 0.8 1434 ` DL7NN JO60 30
2200 -45 0.8 1539 ` R7NT KN97 53
2230 -15 0.8 1434 ` DL7NN JO60 30
2300 -16 0.8 1434 ` DL7NN JO60 30
0000 -7 0.8 1434 ` DL7NN JO60 30
0000 -41 1.4 1539 ` R7NT KN97 53
0100 -8 0.8 1434 ` DL7NN JO60 30
0200 -5 0.8 1434 ` DL7NN JO60 30
0300 -13 0.6 1434 ` DL7NN JO60 30
0400 -13 0.8 1433 ` DL7NN JO60 30
0500 -12 0.8 1433 ` DL7NN JO60 30
0600 -12 0.8 1433 ` DL7NN JO60 30


--
Best regards,
 Chris 2E0ILY mailto:chris@chriswilson.tv


И вот тут, Крис пишет, что использовал магнитную рамку, для съема сигнала с большой рамки, что загнал в резонанс!

Not really, I am using my Wellbrook wide aperture loop as my big horizontal loop I used to use for both TX and RX on LF is being used for HF at the moment. The tuned horizontal loop is a LOT better, to be honest. Good signal from you, I am pleased to be able to give you these reports, take care Alex and all the best.

Следует отметить, что у него там почти идеальные условия приёма и нет помех.

« Последнее редактирование: 02 Август 2021, 20:34:49 от rw3adb »
--_ _ _  _ _ _ --  --_   _   _-_  _--  _ _ _-- _- -_ _ -_ _ _