Длинноволновики всех стран объединяйтесь!
LW-mans of all countries unite!
Просмотр сообщений
В этом разделе можно просмотреть все сообщения, сделанные этим пользователем.
Markus joker)Sorry, my mistake. I had programmed my u-blox module to send FW-30, and at first connected the timepulse output directly to the antenna. Later I activated the PA and forgot to change the sequence. Then the radiated power was actually ~ 0.3 watts.
2022-02-13 23:30 DF6NM 0.137536 -33 0 JN59nj 0.001 R2BAS KO85sv 1908 58 30
Strange, but no one decoded in FW2 (??)Hi Alex, during that night I noticed that WSPR-2 decoded fine at DL0AO, whereas FW-2 was also visible in the waterfall but did not decode. I think the reason was the PC clock deviation due to the broken NTP correction on your side. I think that correct timing is much more critical for FST4 than for WSPR, and it is also less able to handle frequency drift.
June 5-6 Best QRB / reports R7NT actyHi Alex, my LF grabber was alive but had lost internet connection for a couple of nights. 11 spots from Sat/Sun have now been uploaded. 73, Markus
It is a pity that the DL0AO grabber does not workYes we are aware of the problem, the grabber PC froze and we cannot reach it remotely. We intend to go to the site tomorrow and hope that we can fix it.
you were like IR3LW / 120
UA3DJG SKOh no, this is very sad. His beautiful signal was here only a couple of weeks ago, it feels like yesterday. I can hardly believe it.
Another problem is that the Europeans "strangle" the distant reception of each other.At DL0AO and DF6NM, we try to mitigate this problem using SpecLab's "frequency selective limiter" (FSL). In the FFT filter box, you can draw a red line about 20 dB above the noise level. The FSL will then limit all strong carriers to that level. The noise blanker should be installed after the FFT filter in the L4-L5 blackbox. The only disadvantage of this method is that the strong signal itself (e.g. DL0HOT) will be distorted, and the decoder will not show it's full SNR.
